Then, measure the width of the staircase and add 1/2 inch to each sides. Limiting the number of "Instance on Points" in the Viewport, Word order in a sentence with two clauses, Literature about the category of finitary monads, Checking Irreducibility to a Polynomial with Non-constant Degree over Integer, How to create a virtual ISO file from /dev/sr0. Consider a carpet that can withstand heavy traffic and frequent cleaning in a commercial setting. Before you install the carpet, make sure to check the concrete for any moisture issues that need to be addressed. If you're unsure about anything or the work seems too much. kWh usage is inside. Remember to match your carpet to your underlayment. Cover the transition strip with painter's tape to ensure it doesn't get bumped out of place while the glue dries for at least a full day. To make the project even more cost-effective, you can install the carpet yourself rather than employing a contractor. This will lead to tack strips to be easily broken and may require additional stripping. We used the tack strip with concrete nails with no adhesive, but I could see how the condition of the concrete might require it. Using liquid nail glue and galvanized concrete nails, hammer nails . Browse other questions tagged, Start here for a quick overview of the site, Detailed answers to any questions you might have, Discuss the workings and policies of this site. Once you are done the carpet will now be completely installed. Another method is to use adhesive. The surplus dowel rod can be flush cut on the concrete using an angle saw. Keep your rows abutted, and cover seams with duct tape. Subscribe & Get Exclusive Home Improvement Guides. For example, if the total is 46 and you are using 4 tack strips, you will need 12 strips for the room. The size and weight holds them in place (some are also interlocking), and then when they (inevitably) get wet, you can just pull out the ruined ones and replace. ProTip Takeaway. By clicking Post Your Answer, you agree to our terms of service, privacy policy and cookie policy. The tacks should always face the wall. In case nailing is not an option such as drainage systems or radiant heated floors, tack strips can be glued down using urethane construction adhesive or using hot-melt adhesive such as Roadware MATS. Traditional carpet tack strips are composed of 1/8 plywood and are roughly an inch wide. To install most carpets, the carpet material must be stretched before securing it to the floor.