Dr Coco March 21 Day Detox, Emma Personality Type, Riverside County Dpss Forms, How To Merge Two Branches In Visual Studio Code, Bridgewater, Nj Shooting, Articles W

The loosened bolts should be raised with the die and washers and carefully removed so that the dies do not fall down; On the holes are inserted plugs (are included). Slanting or tilting the washing machine can cause the drum to rattle around and lead to possible damage. Appliance-Replacement-Parts. Kogan 8kg Front Load Washing Machine - (KAGFLWASH8A) - Manual These should be removed and you can discard them: Removing the transit bolt from the rear of a new washing machine. Open your front load washer and load 1-3 furniture blankets into the drum so that the inside is full. The first time, the spin at the end (800) was alarmingly loud. Keep the braces and screws for future use. To remove the bolts 1Use a spanner or socket to unscrew and remove all 4 transit bolts at the back of the washer (A). Retain these for future use. Actions should be performed in this order: With the machine Candy things are somewhat different. If you hear the drum thrashing around, you may need to stop and make sure that the blankets are in place. Before installing the washing machine, it is required that you remove all shipping bolts from the back of the unit. And also make sure the wiring to the motor is ok and not come loose. After the performed operations, screw back the cover. If these straps or bars are not correctly removed however they can also cause damage to the washing machine when it is used so it is absolutely vital that you are aware of them and that they are correctly removed before you use your new washing machine. Maybe the machine went for a walk when it hit its spin cycle, or maybe not too much happened. Not having them in can result in damage to the casing from the concrete bashing into the side also damage to the springs or their mounts is possible too. We've used it a few times since. They can tell you a lot more than most will be able to about any appliance you're looking to buy. Pull the black rubber grommets to remove the bolt, grommet and white plastic spacers from the machine (B). On the existing bolt is put on a special die (it goes in the kit); On the bolt with a die, the washers are pinched; The made design is cut into the hole on the wall of the machine body, and the bolt is healed on the drum; After that, the bolt is lowered into the indentation on the opening of the body (the hole looks like a pear shaped); And, finally, the transport bolt is screwed. Also inside is the instruction, in which attention is paid and removal of the transport bolts. Please review your owner's manual to learn how to remove the transport lock so you can install and use your new washing machine. Tighten down the bolt with the wrench.